![]() ![]() Step three: Now you have to prepare the bucket to hang from a tree. When a deer touches the rod, feed will fall from the bucket onto the ground below, where the deer will eat. This screw will serve to keep the rod from falling out of the bucket. The rod will swing back and forth. Step three: Take your dowel rod and stick it through the bottom of the bucket, where it will balance on the screw. The screw should stick out on both sides of the rod, acting as a stopper when you insert the rod into the bucket’s hole. ![]() Take a screw, insert it through the rod at about four inches from an end of the rod, using your screwdriver. Note: If you do end up making the hole too large, you can use black duct tape to make the hole smaller again. The hole should be big enough to let small bits of deer feed through, with the dowel rod stuck in it. Try to err on the side of a smaller hole, as you can always make the hole larger later on, but making it smaller takes more effort. You can use a drill to make a hole in the bottom of your bucket, or alternatively, you can simply use a utility knife. Take your bucket and create a hole in the bottom of the bucket. To give you an idea of the final result you can expect, it should look a little like this: Here is a design for a great deer feeder that’s easy to make and won’t require very complicated material. ![]() How to make your own five gallon bucket deer feeder Otherwise, read along for a great DIY five gallon bucket deer feeder! If you don’t want to do all the hard work yourself, you can also buy very good ready-made deer feeders. There are multiple designs out there, widely different from each other, depending on the spare parts people happen to have available to them. Did you know you can build your own deer feeder out of a five gallon bucket? This is a great option for anyone interested in hunting in the outdoors. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |